Two Inch Suction Nozzle - 3D File
This suction nozzle print without supports and is optimized to work with my two inch subsurface suction dredge tube. The jet has been specifically sized for maximum efficiency when paired with a seaflo 3700GPH bilge pump running the stock impeller, or my custom 3D printer impeller which gives about 20%
Print volume required is 240mm tall and 175mm wide.
Video description here: https://youtu.be/0szcUpa1ChE
File format is .3mf
This file is for personal use only. Please support my work by not selling physical copies online.
This suction nozzle print without supports and is optimized to work with my two inch subsurface suction dredge tube. The jet has been specifically sized for maximum efficiency when paired with a seaflo 3700GPH bilge pump running the stock impeller, or my custom 3D printer impeller which gives about 20%
Print volume required is 240mm tall and 175mm wide.
Video description here: https://youtu.be/0szcUpa1ChE
File format is .3mf
This file is for personal use only. Please support my work by not selling physical copies online.
This suction nozzle print without supports and is optimized to work with my two inch subsurface suction dredge tube. The jet has been specifically sized for maximum efficiency when paired with a seaflo 3700GPH bilge pump running the stock impeller, or my custom 3D printer impeller which gives about 20%
Print volume required is 240mm tall and 175mm wide.
Video description here: https://youtu.be/0szcUpa1ChE
File format is .3mf
This file is for personal use only. Please support my work by not selling physical copies online.
The nozzle has a glue in threaded tip that you can use to screw on and off a variety of the included nozzles and crevicing tips. It also includes a thread on extension tube to get deep down into cracks in bedrock. This model also includes the optional flared connection that can be threaded directly to the two inch subsurface sluice box if you don’t have a suction hose. Multiple models are included in case you want to use a 1-1/8” pressure hose from your bilge pump, or just run the 1-1/2” pressure hose. All the fitting are included.
I found this prints well on my Bambu Labs P1S printer. I always use the liquid glue stick for bed adhesion, and put an internal brim to be extra sure for the taller prints